The thing is aswell, it happens on a certain sort of bass, where the track is at it's most minimal. It can't be bass itself, in production of the track there was absolutely no crackles, I made sure of that. The weird thing too, I exported it to one wav file, no crackles so far.. exported it again with NO mastering settings and the crackle is still there in mp3 or wav file mode, wtf!!! this is blowing my mind. any got any ideas what it could be? like It can't be heard in the project whilst mastering even when fully mastered, always after the export? this track should of been uploaded like two hours ago ffs:( Soundcloud
Also I shoud add it isn't vinyl like crackle, it's almost like when you roughing about with a mic, or when you listened to something recorded in the wind... idk I'll tackle this tomorrow
Update: I seemed to of fixed this but the hiss/crackle is removed only is wav format which was there in both mp3 and wav before, hope that helps someone who wants to answer why this has happened. I went back to th project and fixed a couple comp settings on sub basses and bass, and removed some frequencies around 400 hz, and apparently it now works for wav only, oh well that's good enough!
after some research I think I may of been experiencing alias frequencies around the 400-500 hz range, idk how this started but its a bitch! I just hope this doesn't happen again, will upload the tune later tonight and reply on this thread, and in the dub&feedback forum
I thought I fixed it:( I cannot believe this, it sounded great before I uploaded it to soundcloud, but after upload, it became audible again... Tbh i don't care about it, its for like 5 seconds and the point of this track is to showcase my ideas and sound design, and just my general skill, not mastering, so here it is! Soundcloud
thinking about it I think my mistake was the bass it appears on, I bounced it to audio with a limiter still turned on (I always produce with limiter on, but never export audio with on), I obviously forgot to turn it off, and trying to save cpu I deleted the patch...
so learn from me, don't Bounce audio with a limiter on, cause when it comes to mastering and you add another limiter you may get problems
On a serious note...what mastering software did you use? I found that I used to push ozone maximizer too hard and would get some crackles only when exporting the final wav but not in the playback in the daw. Never figured out why it was never in the playback and only in the exported file but better mixing has made that an issue of the past.
Do you even compress?
exactly why I use a soft clipper instead of a limiter.
When I first knifed man, it felt funny
Next day come, it became funny
I am curious in what context you use the soft clippers. Do you put them in your mix channels and mastering or do you just master with one on the end? I had a look at Figure's track that he posted on Splice a while back and I noticed that he ended his master channel with an Ableton saturator that had clipping enabled.
Users browsing this forum: No registered users and 1 guest