Automating LFO rate on Albino in Ableton Live

globalbabylon · Post by **globalbabylon** » Fri Jul 03, 2009 4:03 am

I have been trying to find the control for the LFO rate in Abletons paramaters list for Albino but no luck, having the same issue with Massive. Anyone know what to look for?

myst · Post by **myst** » Fri Jul 03, 2009 9:31 am

http://www.youtube.com/watch?v=nZYDmw2pYOk

Edit: Do the same with albino. Just assign the lfo to the filter cutoff

vazt · Post by **vazt** » Sat Jul 04, 2009 1:21 am

He said Automation..

double check the filter envelopes in the arrangement but i dont think u can do this yet. If u can.. I want to know.

From what i understand the best way is to u play with the sounds in record mode.. chop up a few different speeds then slice to new midi tracks..

vazt · Post by **vazt** » Sat Jul 04, 2009 7:29 am

was just messing around with this and wat u gotta do in massive is make sure the lfo is not synced idk about albino

iamadam · Post by **iamadam** » Sat Jul 04, 2009 10:35 am

You can do it very easily in live 8, unfold the whatever vst > click configure, click lfo rate, right click show automation. wap

But i which version are you running is the question.

dynamat · Post by **dynamat** » Sat Jul 04, 2009 11:20 am

If you cant find a way like that duplicate the vst and use a different chanel for each rate

Disco Nutter · Post by **Disco Nutter** » Sat Jul 04, 2009 12:07 pm

You can do this with Live 8, or with a vst wrapper... can't remember the name though.

I'll probably check later

graftek · Post by **graftek** » Sun Jul 05, 2009 3:10 pm

Dynamat wrote:If you cant find a way like that duplicate the vst and use a different chanel for each rate

This. Other than that its only possible in live 8.

Disco Nutter · Post by **Disco Nutter** » Sun Jul 05, 2009 5:17 pm

Graftek wrote:
Dynamat wrote:If you cant find a way like that duplicate the vst and use a different chanel for each rate
This. Other than that its only possible in live 8.

Not true... but can't find the name of the vst wrapper I used...
Google around for a VST wrapper.

globalbabylon · Post by **globalbabylon** » Mon Jul 06, 2009 8:50 pm

I'm on live 7. All good advice, been doing the separate channels but its a bit of a pain. You can automate when its not synced in massive, but then you dont get clean steps that match the tempo. Will try recording to a new track and chopping the audio.

Automating LFO rate on Albino in Ableton Live

Automating LFO rate on Albino in Ableton Live

Who is online