Rewiring Reason TO Fruityloops (Separate Mixer Tracks)

[Ficticious]

So as I love the sounds from reason even though every VST/Program can make almost the same sound (they still vary) I am looking to re-wire reason to FL. The problem is, when I do so all of my midi-out's go to the SAME mixer track. This is a huge problem as I am not able to use the Equalization function properly and I am only able to set effects through on and off automation.

In other words, I'm basically screwed unless there is a way to change each midi out to a seperate mixer channel/track somehow.

I have looked up tutorials and have done the search function, I'll look again but if anyone has a quick answer for this problem please take a couple prt screen pictures, draw an arrow and then explain so that I may use my sounds from reason as well.

[Ficticious]

No one knows? Can someone please explain if they do?

[fragments]

This could be solved with audio I/Os on your interface if Reason allows you to output audio to your interface. Send the audio signal of a Reason synth out through the interface and into FL Studio via the interface.

You could also just bounce stuff to audio.

[Bournio]

Can you not use the reason Output device at the top? Press tab and scroll up, link each of your devices to it, then rewire.

[Ficticious]

New to reason still, Haven't used it that much.

Thanks then.

But if I did that, wouldn't I only be able to use my effects in reason? I want to be able to use them in FL through the mixer tracks?

I can't do the other option since I don't have two outputs.

Is my only other way rewiring reason twice over if I want it on a separate channel on the master bus in Fruityloops?

Dono, kinda confused.