Using the second option you'll still have the original power of the sine, where as if you did both in one synth the harmonics from the square would mix with sine harmonic and give it less dB (so the sub bass isnt as hard hitting). 98% of producers will always use a individual synth for the sub bass for this reason, Jakes stresses it a lot
When you have the sine and square on individual channel mixers, balance them out and route them both the one channel so you can see what the total dB output of the bass.
Also slight distortion to the square will give it more grit, but now even thinking it could be done using distortion to just the sine wave.
So, Sine > layered with square/saw with highpass up too 100hz > route both to one channel > lowpass on the whole bass up 1khz or less > and slight distortion on the squ/saw
Users browsing this forum: No registered users and 5 guests