BCR2000 causes computer to reboot

daft cunt · Post by **daft cunt** » Thu Nov 22, 2007 10:47 am

Since my 1212m is fucked I use the BCR's midi ports to connect the Microkorg and since I'm doing this, sometimes - oftenly when I load a track in Renoise - the computer restarts. This never happens while the BCR is off.
I'm pretty sure it's just a matter of unchecking a box allowing the BCR to do that but I can't find it.
Somebody helps?

soi · Post by **soi** » Sat Nov 24, 2007 1:24 am

you still have the bcr-mapping/editing tool that came with it?
i had som crashes too, blue screen saying that bcr was the guilty one..
and check the latest driver off course, but i guess that you already knew that part..

sherbert mastodon · Post by **sherbert mastodon** » Sat Nov 24, 2007 5:26 pm

Behringer. That's the problem right there.

daft cunt · Post by **daft cunt** » Sat Nov 24, 2007 6:22 pm

Soi wrote:you still have the bcr-mapping/editing tool that came with it?

The software editor? It's installed. What's your point?

psychonaught · Post by **psychonaught** » Sun Nov 25, 2007 2:15 pm

ive got the BCD3000 and i have exactly the same problem sometimes. this happens even more when im using my midi keyboard as well. my advice would be to take out as many things that run through usb as possible.

daft cunt · Post by **daft cunt** » Sun Nov 25, 2007 5:42 pm

psychonaught wrote:ive got the BCD3000 and i have exactly the same problem sometimes. this happens even more when im using my midi keyboard as well. my advice would be to take out as many things that run through usb as possible.

I did a fresh install and it seems to work fine with 4 of 6 USB ports loaded.

sherbert mastodon · Post by **sherbert mastodon** » Mon Nov 26, 2007 11:03 am

You're not using a hub are you?

BCR2000 causes computer to reboot

BCR2000 causes computer to reboot

Who is online