Cubase SX3 Issues

manray · Post by **manray** » Mon Feb 25, 2008 8:33 pm

Anyon Zen Cubasers on here?

Just before the 2nd bar on _EVERY_ track i have my cubase has a slight hicup but then carries on as normal. The strange part of this is that it still keeps the timing, you can still mix the beat for example but it seems to spaz out.

Check this example i exported. It happens about half way in.

http://resonant.org.uk/stupid.mp3

(btw i just move my tracks forward 8 bars but still i'd like to fix this so my time code is always right when i look down at it)

cryptic · Post by **cryptic** » Tue Feb 26, 2008 2:23 pm

Mine does the exact same thing.

But when i render, it seems to disapear and goes back to normal.

I always thought it was just my pc.

Im gonna have a good look around to see if i can find out why.

manray · Post by **manray** » Tue Feb 26, 2008 3:04 pm

Your's aint a dodgy copy by any chance is it? hahahaha SABOTAGED MATE ROYALLY SABOTAGED.

danolboy · Post by **danolboy** » Tue Feb 26, 2008 3:26 pm

weird.

cryptic · Post by **cryptic** » Tue Feb 26, 2008 5:16 pm

Me

dogy copys.

No Way lol

b.l.i.t.z · Post by **b.l.i.t.z** » Wed Feb 27, 2008 5:58 pm

this might work

devices > device setup > vstmultirack > change your driver to full duplex driver then ok...

if its already on full duplex driver change it to multidriver then back again then hit ok.. this usally sorts out any latency problems i have

oneliam · Post by **oneliam** » Wed Feb 27, 2008 7:19 pm

Never start a track in Cubase on the first bar, always from the second. Because Cubase sends out a signal to all channels when u press play (on the first bar) which causes a slight skip or time delay. So just set your Left locator to bar 2 and right to where ever and always start the track from there.... hope this helps

Cubase SX3 Issues

Cubase SX3 Issues

Who is online