BASS VST'S

jimmeah · Post by **jimmeah** » Fri May 12, 2006 12:40 pm

I abuse the zeta too much.

Minimoog is a bad one too.

everbody should share their useful homemade patches and samplekits!
dubstep = communism

forensix (mcr) · Post by **forensix (mcr)** » Fri May 12, 2006 12:49 pm

would the albino pastches be backwards compatible with v1 as me no have $$ for v2

8bitwonder · Post by **8bitwonder** » Fri May 12, 2006 12:55 pm

soon as my comp is fixed ill put up some patches for yall

docwra · Post by **docwra** » Fri May 12, 2006 1:16 pm

All i use for making bass is Absynth 3 now.

forensix (mcr) · Post by **forensix (mcr)** » Fri May 12, 2006 2:28 pm

absynth can make the filth bass but programming it takes bare time

docwra · Post by **docwra** » Fri May 12, 2006 4:29 pm

Jus for the fact that you can load samples into absynth 3 man and run them alongside oscillators, endlesss possiblities. Or even just using it as a sampler. The filters and envelopes on it piss over a lot of other synths i have come across aswell.

badsign · Post by **badsign** » Tue May 23, 2006 12:58 pm

http://lanstarr.com/

go to synth/fx

get StarrSynth Free 3. subs n more right outta the box. good for the lazy

komonazmuk · Post by **komonazmuk** » Tue May 23, 2006 8:07 pm

any synth will do for bass... man even my 8 year old son can make a phat bass using the shitist of vst's....try any synth with 2 oscs a low pass filt and an lfo...always start with the basics a sine wave...find the key u like, then layer with 2nd osc..play with tuning to see how the waves phase.... u can get some nasty growlls just by doing this....try tunning cents 25-50 with a square wave...

broken silence · Post by **broken silence** » Wed May 24, 2006 4:09 pm

Iv got the emulator x software, which although is a smapler has hundreds of nice features like lfo's, effects and envelopes for treating your samples. I tend to think of my samples as the oscilator part of a synth and then mangle them to fuck. Some of my favourite basslines are in fact warped kick drums or phased pipe organs (heavy sound, no other acoustic intrument has the SPL of a church organ - recognise).
Any decent soft sampler, and the tastier hardware samplers like yamaha A series or any emu will do the same.

paul@dopesessions · Post by **paul@dopesessions** » Fri Jun 02, 2006 6:18 pm

Heres a good little tip for getting a half decent sub. Go into soundforge and generate a sine wave at 50Hz, for like 2 to 5 seconds.

Set a loop point in the sample, so it loops pure sine seemlessly. Load your sample into your fave sampler, i.e. Kontakt.

...and bang, pure sub up and down the keys, all at the right freq to hit ya chest.

Find this a quick n dirty way to get 'that' sound, good to layer underneath your main bass sound.

meef chaloin · Post by **meef chaloin** » Fri Jun 02, 2006 11:25 pm

v-station...although pretty much any synth can make a nice fat bass, bass sounds are generally not that complex.

antilynd · Post by **antilynd** » Sun Jun 04, 2006 2:47 pm

all about Ableton Operator

BASS VST'S

Who is online