Cubase 5 adding FX to more than 1 Channel

[hideouz]

Is there any easy ways to add FX to more than 1 Channel at a time, say I want to add a filter to everything playing instead of inserting on each channel is there an easy way to group them? I've read a bit about busing but didn't quite understand it and couldn't get it to work with Cubase 5. Sorry if this seems ignorant but I don't have the manual either. Thanks.

[gravity]

make a group channel, then route the outs of the channels you want to effect through the group (you can do this in the output section for each channel).

then put a filter on the group and it will effect everything routed through it.

[Pedro Sánchez]

Create a group channel, put the effect on that, name it 'filter group' then set the output of all the tracks (bussing) you want to filter 'filter group'.
Was said already above so...

Hit up youtube mate and watch some tutorials.

[hideouz]

Thanks guys it's what I did before but I'll give it a go again and tell you how I get on.

[deadly_habit]

you install should have included all documentation as well

[hideouz]

Thanks a lot everyone in this thread, the thing I was doing wrong was trying to drag the channels into the group instead of changing the stereo out, any ideas how I can change the stereo out of more than 1 channel at once + Tone2 BiFilter is amazing but does anyone know of any good filters that also have an lfo? Thanks again

[Pumasneakers]

I'm a spammer