Dubstepforum.com

HALP wrote:
and on a sidenote, i'd like a full analog synth someday

HALP wrote:but all i see is people whining about how big producers with big sounds will most likely be using big expensive analog synths

HALP wrote:no but it happens a lot in general
and i like to exagerate (however thats spelled), i'm sure you know what i mean though

and i'd like a korg ms20 please, but those are hella expensive

+verb wrote:not to speak for slug in any way whatsoever, but he will tell you "i use FL4 only."

and that sound in the video is basically a saw and square, + distortion, and slight envelope modulation on the pitch of the osc's...

the key is using your pitch wheel or assigning the mod wheel to pitch and playing those sweeps and swooshes in real time... or programming the midi pitch cc...

fun stuff can also be had by routing aftertouch to pitch parameters, and applying more pressure via the keys to raise or lower pitch... or again, minus a midi controller??? then program the channel pressure midi cc to achieve same result.

dude is a badman though. layers and layers of slight distortion!

collective wrote:

HALP wrote:no but it happens a lot in general
and i like to exagerate (however thats spelled), i'm sure you know what i mean though

and i'd like a korg ms20 please, but those are hella expensive

one on ebay that wasn't going for too much.

HALP wrote:i like to exaggerate, i'm sure you know what i mean though

omm-0910 wrote:Was just gonna post this: http://www.percussionlab.com/sets/verb/ ... ixtape_004 as an awesome example of this genre of music, and here you are. Mad props btw, this mix has me super inspired to make music

jsills wrote:ok after fucking around for a couple minutes ive got something close to the stab on the 1 from ultra heat treated.
used sylenth.
1 saw -1 octave
1 triangle -1 octave, increased the phase quite a bit and slightly detuned
1 square -1 octave, increase both the phase and detune a little bit.
ran the saw and triangle thru a lpf and took off a tiny bit of the top end.

its not 100% the same but its really really close. give her a shot, hope that halps

nowaysj wrote:

jsills wrote:ok after fucking around for a couple minutes ive got something close to the stab on the 1 from ultra heat treated.
used sylenth.
1 saw -1 octave
1 triangle -1 octave, increased the phase quite a bit and slightly detuned
1 square -1 octave, increase both the phase and detune a little bit.
ran the saw and triangle thru a lpf and took off a tiny bit of the top end.

its not 100% the same but its really really close. give her a shot, hope that halps

Record it and post it bro, let's hear it.