a question about massive..
Posted: Fri Oct 22, 2010 5:05 pm
hello everyone,
i might be really, but then really stupid.. but i've been making a lot of pads lately to expand my own library of synths.. and i can't get massive to undo the next thing: i have (as it is standard in every initialized new patch in massive) hooked up envelope 4 to the AMP of the synth.. now when i play the first note.. as it fades out due to a long release on the envelope.. then i want to play the second note.. so what it does is that it sets a long attack time over the new note again.. but the problem is.. the settings of the AMP are then also used for the previous note which has been played.. so before it even completely fades out.. it 'ducks' to a lower or higher volume again.. and that sounds kinda ugly.. all i want is to have the ADSR sequence hooked up to any given parameter to restart again when i play a new note.. without it affecting the previous note played.
does anyone have a clue what i am doing wrong? i've tried almost everything already.. but i can't seem to change this!
basically it does this with every parameter that i have modulated with envelopes.. so let's say i modulate the wavetable position of an oscillator.. when i play the second note.. the modulated sound in the previous note gets reset to the first starting point of the wavetable position in the second note.. all i want is the first tone/note played to just fade out the way it should
i might be really, but then really stupid.. but i've been making a lot of pads lately to expand my own library of synths.. and i can't get massive to undo the next thing: i have (as it is standard in every initialized new patch in massive) hooked up envelope 4 to the AMP of the synth.. now when i play the first note.. as it fades out due to a long release on the envelope.. then i want to play the second note.. so what it does is that it sets a long attack time over the new note again.. but the problem is.. the settings of the AMP are then also used for the previous note which has been played.. so before it even completely fades out.. it 'ducks' to a lower or higher volume again.. and that sounds kinda ugly.. all i want is to have the ADSR sequence hooked up to any given parameter to restart again when i play a new note.. without it affecting the previous note played.
does anyone have a clue what i am doing wrong? i've tried almost everything already.. but i can't seem to change this!
basically it does this with every parameter that i have modulated with envelopes.. so let's say i modulate the wavetable position of an oscillator.. when i play the second note.. the modulated sound in the previous note gets reset to the first starting point of the wavetable position in the second note.. all i want is the first tone/note played to just fade out the way it should
