Dubstepforum.com

I'm using ableton with a reaktor midrange bass. There is an annoying highptich buzz going on and my spectrum anaylizer doesn't pick it up. It only goes away when I do a steep low cut around 150hz. The problem is it's taking too much low end that the bass sounds weak even with a subbass layer. Any suggestions?

i totally had the same problem recently. don't know.

how high pitched is it if it goes away when you filter 150hz?

i take it its in your reaktor synth? mute each oscillator and work out where its coming from?

i cant imagine its a bug or something, just work out whats making it, and tweak it.

buy it,then it go away

Well the really weird part is on the spectrum analyzer it shows it as energy in the 70 to 150 range but audibly it sounds in the 3-4k range. I would check each oscillator but I already bounced down yesterday. I wish I would have heard it yesterday it would have saved me a lot of work.

valaB wrote:I'm using ableton with a reaktor midrange bass. There is an annoying highptich buzz going on and my spectrum anaylizer doesn't pick it up. It only goes away when I do a steep low cut around 150hz. The problem is it's taking too much low end that the bass sounds weak even with a subbass layer. Any suggestions?

hmm, sounds like a headphone/monitor problem. especially considering the noise isn't showing up on your spectrum analyzer.

bassinine wrote:

valaB wrote:I'm using ableton with a reaktor midrange bass. There is an annoying highptich buzz going on and my spectrum anaylizer doesn't pick it up. It only goes away when I do a steep low cut around 150hz. The problem is it's taking too much low end that the bass sounds weak even with a subbass layer. Any suggestions?

hmm, sounds like a headphone/monitor problem. especially considering the noise isn't showing up on your spectrum analyzer.

that's what i figured when i was getting that issue. didn't get a chance to try a different set though.