Page 1 of 1

Bit-Craft & Ford - Bow Down

Posted: Wed Apr 13, 2011 2:19 am
by Bit-Craft
New collab ;)

Let us know what you think.

Soundcloud

Re: Bit-Craft & Ford - Bow Down

Posted: Wed Apr 13, 2011 2:49 am
by Monstro
Ok, first off, I like the main synth a lot, but I feel like you could throw another synth or two under it to thicken it up a bit. And where does the sub bass sit? I can usually hear bass down pretty far and I cant hear your sub, so maybe its not loud enough or its very VERY low hz. Other than that, sick tune.

Feedback for feedback?

http://dubstepforum.com/viewtopic.php?f=23&t=192829

Re: Bit-Craft & Ford - Bow Down

Posted: Thu Apr 14, 2011 3:10 pm
by Bit-Craft
Thanks for the feedback! =]

We tried layering the synth up a bit more when making it. But whenever we added more it lost a lot of the precision, so in the end we settled on just unison. This was actually made a while ago before I'd discovered camelPhat. Which I think is exactly what we need here to thicken up the bassline a bit. We didn't use a seperate sub when making the bassline because it already has a lot of low-end content and again feared losing precision. I haven't had a chance to listen to it on a sub yet though (neither of us use one in our home setup) so I'll give it a listen on a sub and maybe revisit the bassline with some extra sine waves. =]

Re: Bit-Craft & Ford - Bow Down

Posted: Thu Apr 14, 2011 9:20 pm
by adover
Sounds good, the bassline sounds crazy, but I agree that the bass could be fatter, could you not just split the frequencies into 3 channels and alter the volume of each of them to push the bass through a bit more?

Good work though :thumbs:

Re: Bit-Craft & Ford - Bow Down

Posted: Sun Apr 17, 2011 12:39 pm
by Bit-Craft
adover wrote:Sounds good, the bassline sounds crazy, but I agree that the bass could be fatter, could you not just split the frequencies into 3 channels and alter the volume of each of them to push the bass through a bit more?

Good work though :thumbs:
Thanks. =] It would be easier to just EQ it (same outcome). I think I'm gonna revisit the sub on this when I get back to the studio. WIll post up the results. =]