Dubstepforum.com

I have a question regarding the step sequencer in FL Studio, Lets say I want a Drums section in the step sequencer and then a synth section, both different patterns with different names, how do I make it so only the samples I need in that particular pattern are shown and the rest aren't. This would help a lot because it can get pretty confusing once you have many vst's open and stuff...

Any help much appreciated

- Aprex

Create a group from the channel drop down menu at the top then add your various channels to it.

As you can see, there are already a couple of groups, just add to them. This is incredibly helpful for the end of projects when you've got 100+ automation clips, 100+ audio clips, and like 30 sampler channels.

nowaysj wrote:Create a group from the channel drop down menu at the top then add your various channels to it.

As you can see, there are already a couple of groups, just add to them. This is incredibly helpful for the end of projects when you've got 100+ automation clips, 100+ audio clips, and like 30 sampler channels.

The options I have in the channels drop down menu are:

- Add one
- Clone selected
- delete selected
- move up
- move down


but no create group :S

nowaysj wrote:Create a group from the channel drop down menu at the top then add your various channels to it.

As you can see, there are already a couple of groups, just add to them. This is incredibly helpful for the end of projects when you've got 100+ automation clips, 100+ audio clips, and like 30 sampler channels.

It's ok I got it now It was at the bottom left of my step sequencer, I right clicked and I could create a filter group.

Thank you for your help

- Aprex