Page 1 of 1
fl studio volume question
Posted: Sun Dec 09, 2012 8:40 pm
by nmarch92
when i have channels on my step sequencer, should i raise the volume on the step sequencer all the way to 100 percent and then control the volume on the mixer? because when i load say, a kick drum sample, its a lot lower of a volume then when i preview it in my browser.
Re: fl studio volume question
Posted: Sun Dec 09, 2012 8:48 pm
by mthrfnk
Sequencer.
Re: fl studio volume question
Posted: Mon Dec 10, 2012 1:53 am
by mikeyp
just keep it where it is and worry about the volume when it's time to mix
Re: fl studio volume question
Posted: Mon Dec 10, 2012 2:28 am
by Sure_Fire
It shouldn't be a problem unless you can't enough volume, but you'd have to be working with very quiet samples for that to be an issue.
Re: fl studio volume question
Posted: Mon Dec 10, 2012 10:32 am
by __________
^ if the samples are a really low volume just hit 'normalise' on the sampler and it'll bring the levels up to 0
Re: fl studio volume question
Posted: Mon Dec 10, 2012 12:05 pm
by RandoRando
get the volume right as early as possible in the signal chain, your mixer faders will have better resolution in the end
Re: fl studio volume question
Posted: Mon Dec 10, 2012 7:32 pm
by mthrfnk
RandoRando wrote:get the volume right as early as possible in the signal chain, your mixer faders will have better resolution in the end
This.