Page 1 of 1
splitting inserts in fl studio?
Posted: Fri Feb 22, 2013 1:39 am
by das_raunchy
Is there a way to split 1 insert into 2 inserts? i normally use reason and would just throw it through a spider audio splitter, but i cant find anything about it for fruity loops???
Re: splitting inserts in fl studio?
Posted: Fri Feb 22, 2013 6:38 am
by fragments
You can send any channel to any channel...but no there isn't a way to make one insert on a channel into two inserts. Check out Patcher, it's a super modular routing program native to FL Studio.
Re: splitting inserts in fl studio?
Posted: Fri Feb 22, 2013 12:30 pm
by mromgwtf
Yes it is possible.
Insert 1 is being split into insert 2 and insert 3, and both of them are being sent to master.
Re: splitting inserts in fl studio?
Posted: Fri Feb 22, 2013 3:37 pm
by fragments
^OK. Yea, I wasn't sure exactly what the OP was asking...but was thinking...you can route anything to anything...
Re: splitting inserts in fl studio?
Posted: Wed Feb 27, 2013 12:22 am
by das_raunchy
mromgwtf wrote:Yes it is possible.
Insert 1 is being split into insert 2 and insert 3, and both of them are being sent to master.
ah i guess i didnt turn it up or something. found a way around what i wanted it for but good to know its possible.
