Page 1 of 1
NI Massive sine wave panning.
Posted: Wed Sep 18, 2013 11:55 pm
by Patchwirk
It seems that my sub bass is panning for no reason at all. Here's a screencap with all the relevant information I know of.
http://gyazo.com/c27b90ce12d87a26c197f15aaf3b46d6
Does anyone know what might be causing this?
Re: NI Massive sine wave panning.
Posted: Wed Oct 02, 2013 7:05 am
by Lektrone
If you're routing it through a dimension expander, then go into you OSC tab and activate the button that says "Restart via Gate". After that, you can set the oscillator's to phase properties to any you'd like. Also, try pulling the dimension expander dow a little bit. Or... you could also try to throw a dynamics processor on the channel (such as Ozone 5 Dynamics), and try pulling the lower frequencies down into a mono state. Just a couple of ideas. Hope this helps!
Re: NI Massive sine wave panning.
Posted: Wed Oct 02, 2013 2:21 pm
by Trichome
just make the sub channel mono.
Re: NI Massive sine wave panning.
Posted: Fri Oct 04, 2013 6:32 pm
by titchbit
obviously you have to show us the massive patch m7...