Dubstepforum.com

Hey everyone.

As the title says, I have a quick question about Harmor. Whenever I use the Phaser in an instance of Harmor, the sound somehow changes, almost as if the note doesnt reset.

I made this quick to demonstrate what I mean: https://soundcloud.com/trouncee/for-dsf

It is because the phaser lfo offset doesn't reset as you suspected.

What I do to fix this is set the phaser lfo speed to 0 and automate the phaser offset like so:



Make sure "global" is off and you have the envelope set as a loop. You can also use the lfo control of the phaser offset instead of the env.

GregoryTJ wrote:It is because the phaser lfo offset doesn't reset as you suspected.

What I do to fix this is set the phaser lfo speed to 0 and automate the phaser offset like so:



Make sure "global" is off and you have the envelope set as a loop. You can also use the lfo control of the phaser offset instead of the env.

This did fix the note not reseting, thank you! But how do I adjust the "LFO speed" when doing like this?

Change the distance between the two points, take the one on the far left and drag it closer to the start to make it faster. You can also do time synced phasing this way, just turn on the "tempo" button and drag the far left point to one of the vertical grid lines.

You can't automate the speed of an envelope though, to automate it you would have to use the lfo articulator instead of the env and automate the lfo speed.



Like this.

GregoryTJ wrote:Change the distance between the two points, take the one on the far left and drag it closer to the start to make it faster. You can also do time synced phasing this way, just turn on the "tempo" button and drag the far left point to one of the vertical grid lines.

You can't automate the speed of an envelope though, to automate it you would have to use the lfo articulator instead of the env and automate the lfo speed.



Like this.

Fantastic! This is exactly what I came here for. Thank you very much.

No prob.

I have one more question for y'all. How Do I copy everything from A to B? Like everything, instead of having to copy every little part. I often forget to link the two to begin with, so I was hoping this option is available.

Like this: