Page 1 of 1
Can anyone help
Posted: Mon Nov 05, 2007 11:22 am
by vile
ive just recorded a set through steinberg.wavelab... but its only recorded though one channel.. is there anyway i can split it ??
Posted: Mon Nov 05, 2007 2:00 pm
by janner
you could convert it to stereo by re-sampling in Soundforge or another wave editor
however this is a bit of a 'no-other-options' type suggestion cos if there were any nice stereo details in the recording you will not be able to recapture them...
Posted: Mon Nov 05, 2007 2:19 pm
by drwurst
true for real stereo oyu have to record it in stereo... check your connections
something is ging mono there, could be the settings interface as well,
Posted: Mon Nov 05, 2007 2:27 pm
by chunkie
yeah whatever you do the stereo elements (eg hi-hats panned left etc) will be lost
at worst you can just cut channel 1 into a new project and paste it on both left and right tracks so at least its playing out both channels
Posted: Mon Nov 05, 2007 6:38 pm
by FSTZ
Chunkie wrote:yeah whatever you do the stereo elements (eg hi-hats panned left etc) will be lost
at worst you can just cut channel 1 into a new project and paste it on both left and right tracks so at least its playing out both channels
if you do that reverse the phase on one channel so you dent get phase cancellation (flanging sound)
Posted: Mon Nov 05, 2007 7:00 pm
by two oh one
It's mono. It's fucked.
I think that the only thing you could try, would be to apply a soft stereo spread to it on the mid or upper frequencies and leave your bass mono. It would add some dodgy 'width' and might make it listenable.
Posted: Mon Nov 05, 2007 10:36 pm
by vile
Nice one for the replys!
