Page 1 of 1
Is it possible to set loop points in Reason 4?
Posted: Tue Dec 16, 2008 3:24 pm
by serox
At the moment I have to open samples in Soundforge and chop em up and it takes long to try and get things fitting right.
Is it possible to use either sampler in Reason 4 to set loop points?
Posted: Tue Dec 16, 2008 3:26 pm
by Disco Nutter
You from the future?
Reason 5
Posted: Tue Dec 16, 2008 3:35 pm
by serox
Johnny Beat wrote:You from the future?
Reason 5
what u on about?
:p
Posted: Tue Dec 16, 2008 5:46 pm
by hugh
i dont see why you cant use a Dr Rex with ReCycle to do this.
Posted: Tue Dec 16, 2008 10:07 pm
by serox
Hugh wrote:i dont see why you cant use a Dr Rex with ReCycle to do this.
oh yeh you can I know.
But there are a few DAWs that let you do it live on the fly.
Posted: Wed Dec 17, 2008 5:21 pm
by isidoor
I'm not sure this is what you're asking for, but just load it in the NNXT and use the loop start and loop end knobs to place the loop points?
Posted: Wed Dec 17, 2008 6:10 pm
by -balance-
Yep use the nnxt sampler.