Page 1 of 1
Automating LFO rate on Albino in Ableton Live
Posted: Fri Jul 03, 2009 4:03 am
by globalbabylon
I have been trying to find the control for the LFO rate in Abletons paramaters list for Albino but no luck, having the same issue with Massive. Anyone know what to look for?
Posted: Fri Jul 03, 2009 9:31 am
by myst
http://www.youtube.com/watch?v=nZYDmw2pYOk
Edit: Do the same with albino. Just assign the lfo to the filter cutoff
Posted: Sat Jul 04, 2009 1:21 am
by vazt
He said Automation..
double check the filter envelopes in the arrangement but i dont think u can do this yet. If u can.. I want to know.
From what i understand the best way is to u play with the sounds in record mode.. chop up a few different speeds then slice to new midi tracks..
Posted: Sat Jul 04, 2009 7:29 am
by vazt
was just messing around with this and wat u gotta do in massive is make sure the lfo is not synced idk about albino
Posted: Sat Jul 04, 2009 10:35 am
by iamadam
You can do it very easily in live 8, unfold the whatever vst > click configure, click lfo rate, right click show automation. wap
But i which version are you running is the question.
Posted: Sat Jul 04, 2009 11:20 am
by dynamat
If you cant find a way like that duplicate the vst and use a different chanel for each rate
Posted: Sat Jul 04, 2009 12:07 pm
by Disco Nutter
You can do this with Live 8, or with a vst wrapper... can't remember the name though.
I'll probably check later
Posted: Sun Jul 05, 2009 3:10 pm
by graftek
Dynamat wrote:If you cant find a way like that duplicate the vst and use a different chanel for each rate
This. Other than that its only possible in live 8.
Posted: Sun Jul 05, 2009 5:17 pm
by Disco Nutter
Graftek wrote:Dynamat wrote:If you cant find a way like that duplicate the vst and use a different chanel for each rate
This. Other than that its only possible in live 8.
Not true... but can't find the name of the vst wrapper I used...
Google around for a VST wrapper.
Posted: Mon Jul 06, 2009 8:50 pm
by globalbabylon
I'm on live 7. All good advice, been doing the separate channels but its a bit of a pain. You can automate when its not synced in massive, but then you dont get clean steps that match the tempo. Will try recording to a new track and chopping the audio.