Page 1 of 1
How do I automate pitch with the Combinator?
Posted: Thu Aug 12, 2010 5:42 pm
by nnny
Hey guys, sorry if this has been posted, I searched and could not find it.
Reason 4 problem:
Im wondering how to automate the pitch of my bass with Rotary 2 on the combinator. I figured out how to do this with the LFO Rate, but can't seem to do it with the pitch.
Cheers!
Re: How do I automate pitch with the Combinator?
Posted: Thu Aug 12, 2010 11:44 pm
by Dropkick_Kid
nnny wrote:Hey guys, sorry if this has been posted, I searched and could not find it.
Reason 4 problem:
Im wondering how to automate the pitch of my bass with Rotary 2 on the combinator. I figured out how to do this with the LFO Rate, but can't seem to do it with the pitch.
Cheers!
Right click the patch, should see a thing called pitch bend..
Wallah automate it as you would lfo
Re: How do I automate pitch with the Combinator?
Posted: Fri Aug 13, 2010 6:48 pm
by daddy mchectic
Either right click > automate on the pitch bend dial....or.....see diagram:
1. click show programmer
2. click on the device you wish to assign
3. select the rotary you wish to use and click the square next to it to select the Target
4. find pitch and select it. It'll probably be at the bottom.
Ghetto diagram is ghetto.
Re: How do I automate pitch with the Combinator?
Posted: Fri Aug 13, 2010 6:51 pm
by daddy mchectic
Or instead of pitch bend select 'Osc1(or Osc 2) semitone' instead of pitch bend if you're trying to be more precise.